Installation Diagram Of Indoor And Outdoor Units; Optional Installation Parts - Toshiba RAS-07 series Installation Manual

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

5
3
Batteries
2
Wireless remote control
Remark :
• Detail of accessory and
installation parts can see in
the accessory sheet.
Optional Installation
Parts
Part
Parts name
code
Refrigerant piping
A
: ∅6.35 mm
Liquid side
: ∅9.52 mm
Gas side
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
C
Putty, PVC tapes
EN
Filter
6
Filter
8
Pan head
wood screw
Q'ty
One
each
1
One
each
Hook
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Extension drain hose
(Not available, provided
by installer)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use ∅8 mm or ∅10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple 9 and cap
water proof ! to the bottom plate of the outdoor unit before installing it.
500 mm
Air inlet
97 mm
Air outlet Drain outlet
07 Series
2
For the rear left and left piping
1
Installation plate
Insert the cushion between
the indoor unit and wall, and
tilt the indoor unit for better
operation.
Do not allow the drain hose to
get slack.
Shield pipe
Make sure to run the drain
hose sloped downward.
The auxiliary piping can be
connected to the left, rear left,
rear right, bottom right or
bottom left.
Rear
right
Bottom right
Saddle
Insulate the refrigerant pipes
separately with insulation, not
together.
6 mm thick heat resisting
polyethylene foam
108 mm
32.5 mm
Air outlet
10 Series
Wall
Cut the piping
hole sloped
slightly.
Left
Rear
left
Bottom left
125 mm
Air inlet
90 mm
600 mm
Drain outlet