Table of Contents
Advertisement
E N G L I S H
Never pull the charger lead to
disconnect the charger from
the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
Unplug the charger before
cleaning the charger or the
charging base.
When not in use, the
appliance should be stored in
a dry place. Children should
not have access to stored
appliances.
Inspection and repairs
Before use, check the appliance
for damaged or defective parts.
Check for breakage of parts,
damage to switches and any
other conditions that may affect
its operation.
Do not use the appliance if any
part is damaged or defective.
Have any damaged or
defective parts repaired or
replaced by an authorised
repair agent.
Regularly check the charger
lead for damage. Replace the
charger if the lead is damaged
or defective.
Never attempt to remove or
replace any parts other than
those specified in this manual.
Battery
Never attempt to open the
battery for any reason.
Do not expose the battery to
water.
Do not incinerate the battery.
When disposing of batteries,
follow the instructions given
in the section "Protecting the
Environment".
Charger
Do not expose the charger to
water.
Do not open the charger.
6
ELECTRICAL SAFETY
Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base and the
accessory storage base can be
fitted to the wall to provide a
convenient storage and charging
point for the appliance.
Find a suitable indoor
location near a mains outlet.
Place the charging base over
the accessory storage base as
shown, so that both sets of
holes line up.
Position the assembled
charging / accessory storage
base as shown and mark the
location of the mounting
holes (13) on the wall.
Drill a hole (ø 6 mm, approx.
35 mm deep) at each of the
marked locations.
Insert the wall plugs provided
into the holes.
Fit the assembled charging /
accessory storage base to the
wall using the screws
provided. Guide the charger
lead through any of the 3
slots (14).
Excess lead can be stored at
the rear of the charging base.
Advertisement
Table of Contents
