Before Startup
Unpacking
Check the contents of the pack before
–
unpacking.
In case of transport damage inform ven-
–
dor immediately
Check oil level
Read the oil level display when the de-
vice is not running. The oil level must be
above the two pointers.
Activate deaeration of oil container
Unscrew the fastening screws of the
device hood; remove the device hood.
Cut off tip of oil container cover
Fasten the device hood.
Install hand spray gun, spray lance
and nozzle
1.
Connect ray tube to hand spray gun
Tighten the screw connection of the
spray lance fingertight.
Mount the nozzle on the spray pipe
(markings on the adjustment ring at the
top).
2.
– 3
EN
Attaching the Accessories
In devices without hose drum:
Insert the crank in the hose drum shaft
and lock it in.
Connect the high pressure hose to the
hand-spray gun.
In devices without hose drum:
Lock in the cable hook in the side-hole
on the handle.
For hand-spray guns with threaded con-
nection:
Tighten the high-pressure connection
as required.
For hand-spray guns without threaded
connection:
Lever out the safety clip of the handspray
gun using a screw-driver (Picture A).
Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
Press the safety clip back into the hand-
spray gun. The hose can be pulled out
max. 1 mm if it has been installed cor-
rectly. Otherwise, it means the disc has
been installed wrongly (picture C).
In devices without hose drum:
Before rolling up, stretch out the high
pressure hose.
Wind the high pressure hose in uniform
layers on the hose drum by rotating the
crank. Select the rotation direction in
such a way that the high pressure hose
does not get bent.
17