Panasonic DMP-BD45 Operating Manual (English, Spanish) Operating Instructions Manual page 13

When you experience
problems with settings
Access Point Connection Setting
Access Point Connection Setting
Failed to connect to the access point.
A conflict with another device occurred.
Do you want to configure Access Point Connection
Setting again ?
Yes
OK
Display
A conflict with another
device occurred.
A time out error occurred.
An authentication error or a
time out error occurred.
A device error occurred.
Network Easy Setting (Connection Check)
Network Easy Setting (Connection Check)
Complete.
1. LAN cable connection : Fail
2. IP address setting : Fail
3. Connection to gateway : Fail
LAN cable is not connected.
Please check the connection.
Select "Yes" and press [OK] to check network
connection again. Select "No" and press [OK]
to finish Network Easy Setting.
Yes
OK
Display
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
No
Check the following
≥ Please wait a few moments,
and then try again.
≥ Setting of the Wireless
router (Access point) for
MAC Address etc.
≥ The signal may be weak.
Using the USB extension
cable included with the
Wireless LAN Adaptor,
adjust the position of the
Wireless LAN Adaptor.
≥ The SSID* and the
encryption key of the
Wireless router (Access
point).
≥ Please wait a few moments,
and then try again.
≥ Connection of Wireless LAN
Adaptor
If there is no improvement in
symptom, contact our
Customer Service Center.
No
Check the
following
≥ Connection of
: Fail
the LAN
cables (
: Fail
: Fail
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
Network Easy Setting (Internet Connection Check)
Network Easy Setting (Internet Connection Check)
Complete.
- Connection to the Internet
Failed the connection test.
Cannot find the server.(Error code: B019)
Please refer to the operating instructions for the cause
of the error and the solution for it.
Press [OK].
OK
Display
Cannot find the server.
(Error code: B019)
Failed to connect to
the server.
(Error code: B020)
≥ Refer to the operating instructions of the hub or router.
≥ You can perform this setup anytime by selecting "Network Easy Setting" in
the Setup menu. (
≥ You can redo these settings individually using "Network Settings". (
≥ Do not use this device to connect to any wireless network for which you
do not have usage rights.
During automatic searches in a wireless network environment, wireless
networks (SSID*) for which you do not have usage rights may be
displayed; however, using these networks may be regarded as illegal
access.
≥ After performing network settings on this unit, the settings (encryption
level, etc.) of the Wireless router (Access point) might change. When you
have trouble getting online on your PC, perform the network settings on
your PC in accordance with the settings of Wireless router (Access point).
* An SSID (Service Set IDentification) is a name used by wireless LAN to
identify a particular network. Transmission is possible if the SSID
matches for both devices.
10)
≥ Connection
: Pass
: Fail
: Fail ≥ Settings of
: Pass
: Pass
: Fail
: Fail(Error code: B019)
Check the following
≥ "Primary DNS" and "Secondary
DNS" settings of "IP Address/
DNS Settings" ( 28)
≥ The server may be busy or the
service may have been
suspended. Please wait a few
moments, and then try again.
≥ Settings of "Proxy Server
Settings" ( 28) and the router
28)
and settings
of the hub
and router
"IP Address/
DNS
Settings"
( 28)
28)
13
VQT2H86