Table of Contents
Advertisement
Removal steps of the speaker assembly
Step
Screw (quantity)
1
M2 × 4.6 mm, big head, nylon-coated (4)
When installing:
• Ensure that the connector of the speaker assembly is attached firmly.
• Route the cables as shown in the following illustration.
Attention: As you route the cables, ensure that they are not subject to any tension. Tension could cause
the cables to be damaged by the cable guides, or a wire to be broken.
1180 Fingerprint-reader card
Note: Before you start the servicing, disable the built-in battery. See "Disabling the built-in battery"
on page 60.
Color
Torque
Black
0.181 Nm
(1.85 kgf-cm)
.
Chapter 9
Removing or replacing a FRU
83
Hide quick links:
Advertisement
Table of Contents
