Installation; To Attach Non-Slip Rubbers To The Center; Speaker; To Hang Satellite Speakers From The Wall - JVC TH-A10 Instructions Manual

Installation

To attach non-slip rubbers to the center

speaker

Attach the supplied non-slip rubbers at three points on the bottom of
the center speaker.
Non-slip rubber
Front side
Example ——————————————————
Powered
sub-woofer
Satellite speaker
(rear left speaker)
CAUTIONS:
• For safety reasons, always ensure that there is sufficient place
behind the powered sub-woofer.
• If the front and rear speakers are placed on the floor, always
ensure that they are level.
Downloaded From TheatreSystem-Manual.com Manuals
4
The non-slip rubbers are adhesive.
Peel off the seal before applying.
Attach non-slip rubbers at the three
points shown in the diagram.
Attach two rubbers at left and right at
the front of the speaker, and one in the
middle at the rear.
1 cm (7/16") 5 cm (2")
Bottom
Satellite speaker
Center speaker
(front left speaker)
TV
Center unit
Satellite speaker
(front right speaker)
Satellite speaker
(rear right speaker)
The rear speakers are
placed behind the
listening position.

To hang satellite speakers from the wall

Use the supplied bracket to fix satellite speakers to the wall.
CAUTION: ATTACHING THE BRACKETS ON THE WALL
When attaching the brackets on the wall, have them attached
to the wall by a qualified person.
DO NOT attach the brackets on the wall by yourself to avoid
an unexpected damage of their falling from the wall, caused
by incorrect attachment or weakness in the wall.
Location of attachment to wall:
Care is required in selecting a location for attaching satellite
speakers to the wall. Injury to personnel, or damage to
equipment, may result if the speakers are attached in a
location which interferes with daily activities.
Attaching speakers to the bracket ————————
1.
Use the screw supplied to attach the speaker to
the bracket.
2.
Adjusting the angle of the satellite speakers
The angle of the speaker may be adjusted in the front-rear and
left-right directions along the channel in the bracket.
When adjusting the angle, loosen the screw slightly, make the
adjustment, and then tighten the screw firmly.
Tilting the speaker to the front
Tilting left-right
Bracket
Screw
CAUTION:
If the screw is not tightened
firmly, it may cause injury to
personnel or damage to
equipment.