Roland CM-110 Owner's Manual page 13

Using Microphone Stands
WARNING: The stability using microphone stands other than the folding stand integral with the speaker has not been evaluated for
safety and can result in hazardous injury to the user.
The satellite speakers are designed so that non-Roland specified microphone stands can be used to support them. By mounting the satellite speakers
on non-Roland specified microphone stands, you can position them at the optimal height for use as monitors or as a convenient PA system.
The microphone stand holder on the bottom of each satellite speaker provides two holes: 3/8" and 5/8". Use the hole that's appropriate for your
microphone stand.
5/8" diameter
• As shown in the illustration below, open the legs of the microphone stand (50 cm or more), and position it so that the total height (including the
satellite speaker) does not exceed 105 cm.
50 cm (19-11/16")
or more
• If the microphone stand is higher than 105 cm (including the satellite speaker), or if the legs are not spread out, the stand and speaker may tip
over, causing injury or damage.
• When using microphone stands to support the satellite speakers, do not place them at unstable or inclined locations. You must place the stand on
a stable and horizontal surface.
• Make sure to appropriately manage the cables connected to the satellite speakers so as to prevent accidents, such as might be caused by
someone tripping over them.
• To prevent the stand and speaker from tipping over, do not place anything on a satellite speaker mounted on a microphone stand.
• After mounting a satellite speaker on a microphone stand, be sure to verify that it does not wobble.
• Be sure to get the assistance of at least one other person when mounting a satellite speaker on a microphone stand, or when adjusting the height
of the microphone stand while the satellite speaker is mounted.
• Firmly tighten the hardware of the microphone stand so that the satellite speaker does not move to left or right.
• Take care not to pinch your fingers when mounting the satellite speaker.
• Use a microphone stand that is strong and durable, such as one made from aluminium or steel.
3/8" diameter
105 cm (41-3/8")
or less
WARNING
11