Electrical Connection - Beko DCU 9330 X User Manual

Connecting the water drain hose;
1. Remove the hose on the machine by pulling it out
from its end. Do not use any tools to take out the
hose.
2. Connect the special drain hose supplied with the
machine to the pipe fitting.
3. The other end of the drain hose can be directly
connected to the wastewater drain or to the
washbasin. The fitting must always be secured in
all types of connections. Your house may be flooded
if the hose gets out of its housing during water
discharge.
Important:
• The hose should be attached to a height of maximum
100 cm.
• You must be careful not the pinch or bend the hose.
• The end of the hose should not be bent, it should not
be stepped on and it must not be folded between the
drain and the machine.
Adjusting the feet
In order to ensure that your machine operates more
silently and vibration-free, it must stand level and
balanced on its feet. Balance the machine by adjusting
the feet.
Rotate the feet to adjust until the machine stands level
and firmly.
C
Never unscrew the adjustable feet from their
housings.

Electrical connection

Connect the machine to a grounded outlet protected
by a fuse of suitable capacity as stated in the technical
specifications table. Our company shall not be liable for
any damages that will arise when the machine is used on
a circuit without grounding.
• Connection must comply with national regulations.
• If the current value of the fuse or breaker in the house
is less than 16 Amps, have a qualified electrician
install a 16 Amp fuse.
• Power cable plug must be within easy reach after
installation.
• The voltage and allowed fuse or breaker protection
are specified in the "Technical Specifications" section.
• The specified voltage must be equal to your mains
voltage.
• Do not make connections via extension cables or
multi-plugs.
• The main fuse and switches must have a contact
distance of minimum 3 mm.
B
Damaged power cable must only be replaced by a
qualified electrician.
B
If the product is faulty, it must not be operated unless
it is repaired! There is the risk of electric shock!
First use
• To have the product ready for operation before
calling the authorised service agent, make sure
that its location and power supply installations are
appropriate. If they are not, call a qualified electrician
to have any necessary arrangements carried out.
• Make sure that the power connections of the product
are in accordance with the instructions given in
relevant chapters of this manual.
Transportation of the machine
1. Unplug the machine from the mains.
2. Remove the water drain (if any) and chimney
connections.
3. Drain water remained in the machine completely
before transportation.
6 EN