Remote Control And Buttons; Sr 9 Remote Control; Using The Sr 9 Remote Control - NAD C 368 Owner's Manual

Hybrid digital dac amplifier
Hide thumbs Also See for C 368:
Table of Contents

Advertisement

USING THE SR 9 REMOTE CONTROL

The SR 9 remote control handset handles the key functions of the C 368 as well as other NAD Stereo
Receivers, Integrated Amplifiers and Preamplifiers. It has additional controls to remotely operate NAD
CD Players, AM/FM Tuners and dedicated AM/FM/DAB Tuners. It will operate up to a distance of
23ft (7m). Alkaline batteries are recommended for maximum operating life. Two AA batteries should
be fitted in the battery compartment at the rear of the Remote Control handset. When replacing
batteries, check that they have been put in the right way round, as indicated on the base of the battery
compartment.
NOTE
The remote control handset supplied with the C 368 is of a universal NAD type, designed to operate
several NAD models. Some buttons are applicable only to specific NAD models. Contact your dealer
or NAD audio specialist for assistance.
1 POWER ON & OFF: The SR 9 remote has a separate ON and OFF button. Press the ON button
to switch the unit from Standby to operating mode. Press the OFF button to switch the unit to
Standby mode.
2 DEVICE SELECTOR: A Device Selector button determines only what component the SR 9 will
command; it does not perform any function on the C 368. Press desired Device Selector button
for the applicable buttons to be directed to a "page" of commands relevant to the selected device.
Upon selecting a Device, you can now press the corresponding SR 9 control buttons applicable for
the selected Device.
3 INPUT SELECTORS: Refer to the corresponding labels printed in the remote control faceplate
and their respective assigned buttons to make use of these functions. Set the DEVICE SELECTOR to
"AMP" in order to gain access to these buttons.
4 NUMERIC KEYS: The numeric keys allow for direct input of tracks for CD players, and direct
channel/preset access for tuners and receivers.
5 SLEEP: Switch off specific NAD Receiver or Tuner models after a preset number of minutes. This
button control does not apply to C 368.
6 MUTE: Press the [MUTE] button to temporarily switch OFF the sound to the speakers and
headphones. MUTE mode is indicated by the Standby LED indicator flashing for NAD Integrated
Amplifiers or "Mute" shown in the VFD of NAD Receivers. For C 368, "Mute" is shown in the display.
Press MUTE again to restore sound. Adjusting the volume level via the SR 9 or the front panel
volume knob will automatically release the mute function.
7 SOURCE 5/6: Toggle through the source input selections. If the optional MDC modules are
installed, the source selections will include the sources incorporated in the applicable modules.
8 DIM (for use with NAD Stereo Receiver, Tuner and CD Player): Reduce, turn off or restore VFD
brightness. Depending on the NAD model, the brightness of the front panel display will vary when
you toggle this button. For C 368, toggle to vary brightness level of the display - brighter, normal or
dimmer (not applicable if current dimmer setting is "Temporary").
IDENTIFICATION OF CONTROLS

SR 9 REMOTE CONTROL

1
COAX 2
3, 4
6
7
SOURCE
2
BLS
OPT 1
OPT 2
COAX 1
PHONO
LINE 1
LINE 2
USB
BT
5
8
SCAN
9
TUNE
10
11
SR 9
9
SCAN
TUNE
SOURCE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents