Makita TD0101 Technical Information page 12

W
iring diagram
Fig. D-4
Wiring around Holder arm
Guide Field lead wires (purple, orange)
inside the Rib of Holder arm to avoid
pinching between Housing set (R) and
Holder arm.
Holder arm
Rib of
Holder arm
Wiring of Field
lead wires
Fix Field lead wires (red, clear)
with Lead wire holders on Switch.
Noise suppressor
Terminal block
220-240V area except
Argentine, Chile etc.
Rib
Noise suppressor is
not used for some
countries.
Put Insulated connector
into the area which is
surrounded by Ribs.
TD0101F
Argentine, Chile etc. 220-240V area
where Noise suppression is required
Rib
Rib
Wiring of Lead wire (brown
or black) of Power supply cord
Through the route between the following
ribs, guide the above lead wire to Switch.
* Ribs for setting Noise suppressor
* Ribs for setting Terminal block
Wiring of Lead wire (orange)
of left Brush holder and
Field lead wire (white)
Guide field Lead wire (white)
between Lead wire holder and Ribs.
Lead wire (orange)
of left Brush holder
Guide Lead wire (orange)
of left brush holder by Ribs.
Wiring of Noise suppressor's
Lead wires
Guide the Lead wires of Noise suppressor
between Ribs.
* Lead wire (black) to Switch
* Lead wire (black) to LED circuit
* Lead wire (clear) to Field
LED Circuit
P 12/ 14
Field lead
wire (white)
Rib
Lead wire
holder on
Switch