Whirlpool FSCR12420 Health & Safety, Use & Care And Installation Manual page 41

Failure
Display message
indicator
F20 or
F60
F24
SERVICE
F02
All other F . . failures Failure of an electrical
Possible Cause
Failure of an electronic com-
ponent
Too much laundry for a pro-
gramme with small maxi-
mum load
Too much inlet water
Water stop failure – water
leakage detected in bottom
tray .
component
Possible Solution
Switch off and unplug the
washing machine; close the water
tap .
Call After-Sales Service
Select and start programme
"Rinse and Spin" to complete the
interrupted wash programme .
Do not overload the washing
machine . Respect the maximum
load size of the programmes
indicated in the Programme
Chart .
Turn off the water tap . Press and
hold On/Off for at least 3 seconds
to drain the water; wait until the
drain phase has ended (End will
appear on display) .
Turn on the water tap again . – If
water immediately flows into the
washing machine (without having
started a programme), there is a
failure of an electrical component .
Close water tap, switch off and
unplug the washing machine .
Contact our After-Sales Service .
Press On/Off for at least 3
seconds . If failure persists, contact
After-Sales Service .
Press On/Off button for at least
3 seconds to reset the failure . If
problem persists, switch off and
unplug washing machine . Close
water tap . Call After-Sales Service .
EN
41