Philips Sonicare DiamondClean HX9332/04 Service Manual

Philips Consumer Lifestyle
Service Manual
SERVICE POLICY
Product will be serviced for 3 years after End of Life.

PRODUCT INFORMATION

Easy-start
the Easy-start feature will gradually increase the sonic power
over the first 14 brushings. Brushing must last at least 1 minute
to properly advance through this ramp-up cycle. Easy-start may
be deactivated - Place the handle in the plugged-in charger
(either charging base or travel case) - Push and hold the on/off
button for 2 seconds; 1 beep indicates the Easy-start feature has
been deactivated; 2 beeps indicate the feature has been
reactivated.

Quadpacer

The Quadpacer is an interval timer that has a short beep and
pause to remind you to brush the 4 sections of your mouth.
Depending on the brushing mode you have selected, the
Quadpacer beeps at different intervals during the brushing cycle.
Clean The ultimate in plaque removal (Standard mode).
White 2 minutes of whitening mode to remove surface stains and 30
seconds to brighten and polish your front teeth.
Polish Quick 1-minute mode to brighten and polish your front teeth.
Gum care Complete mode combines Clean mode with an additional
minute to gently stimulate and massage gums to improve gum health.
Sensitive Extra gentle mode for sensitive teeth and gums.

Charging

It takes at least 24 hours to fully charge the battery.
Charge for 24 hours before first use. Charge indicator flashes
green until fully charged. Rapid yellow flashing indicates charge
is extremely low (fewer than 3 uses left). The charger is
designed to properly charge only one (1) handle at a time. Do
not place metallic objects in the charger glass as handle charging
may be affected and may cause the charger to overheat.
Published by Philips Consumer Lifestyle
4235 006 33161-671_ 13-08-02
(YY_MM_DD)
HX9332/04 DiamondClean Retail UK, EU, ASIA
HX9333/04 DiamondClean Retail Japan
HX9332/05 DiamondClean Retail US
HX9382/04 DiamondClean DP UK, EU
HX9382/02 DiamondClean DP Japan
HX9382/05 DiamondClean DP US
HX9340 (Handle)
Note: This charger is not compatible with previous models of
Sonicare.
Charging – other options
Charge via wall outlet - Place the handle in the charging travel
case, plug the USB cord into the travel plug, and plug into an
electrical outlet. The charge indicator on the handle flashes
green until fully charged.
Charge via USB - Remove the USB cord from the travel plug,
and insert the USB plug into any USB port. Use Only Philips
USB wall adapter and USB cable provided. Use Only UL
Listed devices as an alternate method of charging the toothbrush
handle in the travel case (i.e. UL listed Computer, USB Hub).
Cleaning
Clean the Sonicare periodically. Wipe down and rinse the entire
surface with a soft cloth and mild soap, if desired. Do not use
sharp objects to clean. Do not clean brush heads, handle,
charging base, or travel charger in the dishwasher. Charger glass
is top rack dishwasher safe.

SAFETY INFORMATION

To reduce the risk of burns, electrocution, fire or physical injury:
• Do Not use attachments other than those recommended by
the manufacturer.
• Do Not plug the charger into an outlet with a voltage other
than specified on the bottom of the charger. This product is
designed to operate within a range of 100 to 240 volts. Voltage
converters Do Not warrant voltage compatibility.
• Never force the plug into an outlet; if the plug does not easily
fit into the outlet, discontinue use.
• Discontinue use if the product appears damaged in any way
(brush head, handle, charger).
• Do not use the charger if it has dropped into water.
• Keep the cord away from heated surfaces.
• Do not use the charger outdoors.
• This product contains no user-serviceable parts. Refer to
Printed in the Netherlands © Copyright Reserved
Sonicare toothbrush
Subject to modification