Do Not Tilt The Projector More Than 15 Degrees - Barco RLM W12 User Manual

RLM
Warning, Notices and Safety Instructions
W12
cleaned routinely to prolong the projector's lifecycle. Cleaning of the projector's interior should
only be performed by qualifi ed service personnel dispatched by your local dealer and you
should not attempt to clean the inside of the projector by yourself.
If other light source is directly projected onto the projector screen, the color of the image from
the projector will appear to be pale and the image quality will be lower. In addition, your eyes
would be more prone to fatigue. Therefore, it is recommended that the projector be installed
in places without direct exposure to sunlight or other sources of intense light.
The ideal operating temperature range for the projector is between 32°F ~ 104°F (0°C ~ 40°C)
The ideal storage temperature range for the projector is between -4°F ~ 104°F (0ºC ~ 40°C)

Do not tilt the projector more than 15 degrees.

The maximum tilt angle for the projector is 15 degrees.
When the projector is tilted more than 15 degrees, it will shorten the life of the projector lamp
and may lead to other unpredictable damages.
Can't >15°
Can't >15°
Confi gurations for projector operation at high altitudes
When operating the projector at higher altitudes, be sure to manually set the fan mode to "High"
or it could shorten the life of the optical system in the projector.High altitude is defi ned as
places being 1500 meters (4900 feet) or higher.
Please refer to " Page 44 : High Altitude Mode ".
Keep the projector's ventilation inlets and outlets free from obstructions
Be sure to keep objects for no less than 30cm away from the ventilation inlets and outlets of the
projector and note the direction of air fl ow at the designated spot of installation. Do not let the
hot air released from the outlet fl ow back to the inlet as it will prevent proper cooling and lead to
damage of the projector's internal structure.
In the event of high temperature due to malfunctioning of the internal cooling fan caused by
clogging at the ventilation inlets and outlets, the projector will activate its automatic protection
mode and shutdown. When this happens, it does not necessary mean that the equipment is
malfunctioning. Try to unplug the power cord from the wall outlet and wait for approximately 15
minutes before operating the projector again (remember to remove the objects that have caused
poor ventilation so that the projector will not go into the protection mode again). Please refer to "
Page 58 : LED STATUS ".
Description: The regulation of temperature inside the projector by the cooling fan is automatic. And
as such, the sound of cooling fan changing its operating speed does not imply that a problem has
occurred with the projector.
Protect the projector with care
When placing the projector at a high position, be sure to secure the projector fi rmly so that
it would not fall and cause injuries.Take care to protect the projector's lens from collision,
abrasion or other damages.Be sure to close the lens cover or cover the projector with a dust
cover if you need to store the projector or if it will not be used for an extended time.
8