PIAGGIO MSS X10 500ie Executive Service Station Manual page 145

MSS X10 500ie Executive
Suspensions
- Fit the spacer between the two ring nuts on the
steering tube in the position indicated.
- Insert the upper tightening ring nut, screw until it
stops and, with the specific tool, tighten to the in-
dicated torque.
Specific tooling
020055Y Wrench for steering tube ring nut
Locking torques (N*m)
Steering tube upper ring nut
40 to 45
Insert the collar shown in the figure and restore the
cable passage as shown in the figure.
A - Left brake lever pump pipe.
B - Throttle grip cables.
C - Left control block cable harness.
D - Right control block cable harness.
E - Right brake lever pump pipe.
SUSP - 145