Set Up Your Machine; Spool Pins - Singer SEQS-6700 Instruction Manual

SET UP YOUR MACHINE

Be sure to wipe off any surplus oil from needle plate area
POWER LINE CORD/FOOT CONTROL
Connect the plug of the power line cord into the cord
socket (1) and your wall outlet (2) as illustrated.
Connect the foot control plug into the machine socket (3),
when using sewing machine only.
NOTE: In sewing mode, the machine can be operated either
with or without the foot control (see page 15).
Always disconnect the machine from power
supply by removing the plug from the wall
outlet.
POWER/LIGHT SWITCH
Your machine will not operate until the power/light switch
is turned on. The same switch controls both the power and
the light.
When servicing the machine, or when changing needles
or lights, etc., the machine must be disconnected from the
power supply.
Power/light switch "OFF"

SPOOL PINS

HORIZONTAL SPOOL PIN for normal
thread spool
Place thread spool on the pin and secure with a spool cap
VERTICAL SPOOL PIN for large thread
spool
Attach the spool pin. Place felt disc over it. Place a thread
spool on the spool pin.
4
Spool pin cap
Set power/light switch at
"OFF"
4
Pin
Power/light switch "ON"
Spool
Vertical spool pin
Thread retaining slit
Spool
Spool pin
Machine socket
1
3
Power line cord
Foot control
Felt disc
2