Get The Phone Ready; Battery And Charger; Battery Capacity; Install The Battery - Kyocera duraxe User Manual

Get the Phone Ready

You must first install and charge the battery to begin setting up your phone.

Battery and Charger

Warning: Use only Kyocera-approved batteries and chargers with your phone. The
failure to use a Kyocera-approved battery and charger may increase the risk
that your phone will overheat, catch fire, or explode, resulting in serious
bodily injury, death, or property damage.

Battery Capacity

Your phone is equipped with a Lithium Ion (Li-Ion) battery. It allows you to recharge your
battery before it is fully drained.
For a quick check of your battery level, glance at the battery percentage displayed in the
center of your phone's Home screen or the battery charge icon located in the upper right
corner of the screen. When there are approximately ten minutes of talk time left, the
battery icon turns to
approximately five minutes of talk time left, the battery icon turns to
Note: To turn on the battery percentage display or turn it off, from the Home screen,
press Menu (center softkey) > Settings > Device > Display > Main clock and
select On or Off. See
Note: Long backlight settings, searching for service, vibrate mode, browser use, and other
variables may reduce the battery's talk and standby times.
Tip: Watch your phone's battery level and charge the battery before it runs out of power.

Install the Battery

1. Using a coin, rotate the battery door screw on the back of the phone counter-
clockwise several times to loosen (you should hear a 'click' sound when the screw is
loose).
Phone Basics
and the phone sounds a warning tone. When there are
Clock Display.
12
.