Disposal Of The Appliance - Hotpoint DXU7 912 C IX Instructions For Use Manual

If something
goes wrong...
Problem
GB
Oven light does not
work
Draught from
beneath control
panel
Steam /
Condensation in
the oven after use.
If you have been through the above list and there is still a problem, contact Service (see back page).
Problem
The "Clock button" and the
digits on the display flash.
A programmed cooking mode
does not start.
Only the high luminosity
"Clock button" is lit.
An automatic mode has been
selected. "Hot" appears on the
display and cooking does not start
Fan-assisted cooking has been
selected and the food looks burnt.
Disposal of your product
To minimise the risk of injury to children please
dispose of your product carefully and safely.
Remove all doors and lids. Remove the mains cable
(where fitted) by cutting off flush with the appliance
and always ensure that no plug is left in a condition
where it could be connected to the electricity
supply.
To help the environment, Local Authority instructions
should be followed for the disposal of your product.
Disposal of old electrical appliances
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
26
Check
The oven lamp is not covered by the guarantee. The part is easily changed (see the section
on oven lamp replacement). A new lamp may be obtained from our Parts department see
back page.
A gentle flow of air will be blown from beneath the control panel when the appliance is
used. If the appliance is still warm, this cooling fan may run on, or restart itself when all
controls have been turned off. The fan will stop once the appliance has been cooled. This
is normal and not a fault.
Steam is a by - product of cooking any food with a high water content. To help minimise
always:
a) Try to avoid leaving food in the oven to cool after being cooked.
b) Use a covered container, wherever possible.
Possible cause
The appliance has just been
connected to the electricity
mains or there has been a blackou
There has been a blackout.
The appliance is in standby mode Press any button to exit
The temperature inside the oven
is higher than the suggested value
for the selected mode.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
Solution
Set the clock.
Reprogram the cooking mode.
standby mode.
Wait for the oven to cool down.
We recommend switching
dripping pan positions halfway
through cooking.