PAC SWI-RC Installation Instructions Manual page 5

Programming the SWI-RC to Control the Head Unit (cont.)
Step G.
After all buttons are
programmed
Testing the SWI-RC
A. When testing the audio controls, the left LED on the
SWI-RC will flash indicating it is sending a command.
If any function does not work, repeat the programming
instructions (starting from Step 11) or refer to
Troubleshooting Guide.
Appendix A.
If you programmed the interface for version #4, proceed with the following steps.
If you did not program the interface for version #4, please disregard.
Step A.
Turn the vehicle ignition to
the ON position.
Step B.
Press and hold
programming/
mode button
on SWI-RC.
Step C.
Release
programming/
mode button.
Step D.
Press and hold the TEMP UP
button on the steering wheel
control.
Step E.
Release the TEMP UP button.
IGN
ACC
STRT
OFF
LED will turn
off
TEMP
TEMP
Once programming is
wait 7 seconds
completed,
The LED will flash three times
indicating end of programming.
The Interface will then flash the
vehicle version number it was
programmed for.
VOL
LED will light.
06-18-10
.
LED will flash 4 times
to indicate set version
number.
LED will turn off.
LED will turn on. The
function is pro-
grammed.
5