Seat Belt Replacement; High Back Bucket Seat Belt Replacement - GMC G Service Manual

10A2-6 SEATS
3. Catch (28) with bushing (29).
4. Washer (30).
5. Seatback to seat base bolt (26).
6. Washers (30) and (71).
7. Seatback from the vehicle.
h + l Install or Connect (Figure 5)
1. Seatback to the vehicle.
2. Washer (30) between the seat base and the seatback
frame.
3. Seatback to seat base washer (71) and bolt (26).
4. Washer (30).
5. Catch (28) with bushing (29).
6. Striker (27).
7. Seat back trim cover (32).

SEAT BELT REPLACEMENT

This procedure covers belts for all seats except high
back bucket seats.
M Remove or Disconnect (Figures 6 and 7)
1. Upper seat belt anchor plate cover (42).
• Pry the top of the cover away from the anchor
plate.
2. Anchor plate bolt (36).
3. Anchor plate (35).
4. Plug (39) (if equipped).
5. Retractor (33) to floor bolt (40).
6. Seat belt wire (41) (left side only).
7. Retractor (33) from the vehicle.
8. Plug (37).
9. Buckle (34) to floor bolt (38).
10. Buckle from the floor.
H
10. Upper seat belt anchor plate cover (42).
HIGH BACK BUCKET SEAT BELT
M
33. Retractor
34. Buckle
35. Anchor Plate
36. Bolt
37. Plug
38. Bolt
39. Plug
40. Bolt
41. Seat Belt Wire
42. Cover
Figure 6 — Bucket Seat Belt Components
Install or Connect
NOTICE: For steps 2, 6, and 9 see " Notice" on
page 10A2-1 of this section.
1. Buckle (34) to the floor.
2. Buckle to floor bolt (38).
Tighten
• Bolt to 50 N»m (37 ft. lbs.).
3. Plug (37).
4. Retractor (33) to the vehicle.
5. Seat belt wire (41) (left side only).
6. Retractor to floor bolt (40).
H O Tighten
• Bolt to 50 N»m (37 ft. lbs.).
7. Plug (39) (if equipped).
8. Anchor plate (35) to the door pillar.
9. Anchor plate bolt (36).
H D Tighten
• Boll to 50 N-m (37 ft. lbs.).
• Pivot the cover upwards, and press it into place.
REPLACEMENT
Remove or Disconnect (Figure 8 and 9)
1. Upper seat belt anchor plate cover (42).
• Pry the top of the cover away from the anchor
plate.
2. Anchor plate bolt (36).
3. Anchor plate (35).
4. Retractor lower flap (54).