R/V Model Front Seats; Front Seat And Seat Adjuster Replacement - GMC G Service Manual

• Slide the spring off of the hook.
• Open the hook, and remove it from the hole.
• Move the hook to a forward hole to loosen the
wire, move the hook to a rearward hole to
tighten it.
• Close the hook, and slide the spring over the
hook.
• Install the seat. Refer to "Front Seat and Seat
Adjuster Replacement."
FRONT SEAT AND SEAT
ADJUSTER REPLACEMENT
This procedure applies to all R/V Model front seats,
whether bench or bucket type with the exception of the
utility vehicle passenger front bucket seat. Refer to "Utility
Vehicle Passenger Front Bucket Seat Replacement" for
information on this type of seat.

R/V MODEL FRONT SEATS

Figure 2 — Bench Seat Components
Figure 1 — Adjustment Points
H Remove or Disconnect (Figures 2 and 3)
1. Bolt cover (5) (if equipped).
2. Seat adjuster to floor panel bolts (7).
3. Seat (10) with adjuster (2) from the vehicle.
4. Adjuster to seat bolts (8).
5. Adjuster (2) from the seat (10).
SEATS 10A2-3
Adjuster
F-00489
Wire
Adjuster
Screw
Cover
Spring
Bolt "
Bolt
Seat
F-00490