Jacket Assembly; Terminal Block; Fusing - Bradford White VR-150-(kW) Installation And Service Manual

DO NOT CONNECT THE WATER HEATER TO AN IMPROPER SOURCE OF ELECTRICITY!
Never turn on the electric power or attempt to use this electric water heater unless it is completely
full of water. Water must flow from the hot water faucet before turning electrical power "ON."
Operation of a water heater without a completely filled tank may result in serious damage to the
appliance and heating element burn out.

JACKET ASSEMBLY:

Outer Jacket - The outer jacket assembly is constructed from steel, painted with enamel on both sides. This
coating process insures a long life from the jacket assembly.
STANDARD EQUIPMENT:
Your commercial electric water heater is equipped with the following as standard equipment:
• Low watt density immersion heating elements with an incoloy sheath.
• Internal fusing of all elements in a maximum of 48 amp increments provides additional safety. Fuse
cartridges are related at 1,000,000 amps interrupting capacity.
• A painted enamel steel outer jacket and electrical control panel are provided.
• Channel iron skid base.
• Electrical control panel is provided with a hinged door and key lock.
• A glass lined steel tank constructed to ASME specifications and provided with magnesium anode(s).
• ASME rated temperature and pressure relief valve provided by factory to insure safe heater operation.
• Terminal block connections are installed by the factory for safe easy wiring connection.
• Manual reset high water temperature limit control.
CAUTION:
CAUTION:
11