Replacing The Front Audio And Usb Assembly - Lenovo ThinkCentre 0266 User Manual

5. Press the internal speaker lock latch
chassis.
Figure 30. Removing the internal speaker
6. Position the new internal speaker into the metal clips
secured by the lock latch
7. Connect the new internal speaker cable to the system board. See "Locating parts on the system
board" on page 10.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 51.

Replacing the front audio and USB assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
safety information" on page vii.
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Open the computer cover. See "Opening the computer cover" on page 28.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 28.
4. Disconnect the front audio and USB assembly cables from the system board and note the cables
routing. See "Locating parts on the system board" on page 10.
1 , slide the internal speaker downwards to remove it from the
1 .
2 and push the internal speaker upwards until it is
.
Chapter 5 Installing or replacing hardware
45