Dell Inspiron Mini 9 910 Service Manual page 25

Removing the Mini-Card
1. Follow the instructions in Before You
2. Remove the module cover (see
1 Mini-Card
3 antenna cable connector (2)
3. Disconnect the antenna cables from the Mini-Card.
4. Release the Mini-Card by removing the securing screws.
5. Lift the Mini-Card out of its system board connector.
NOTICE: When the Mini-Card is not in the computer, store it in protective antistatic packaging. See the information on protection against electrostatic
discharge in the safety information that shipped with your computer.
Replacing the Mini-Card
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and
realign the card.
NOTICE: To avoid damage to the Mini-Card, never place cables under the card.
1. Follow the instructions in Before You
2. Remove the new Mini-Card from its packing.
NOTICE: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.
Begin.
Removing the Module Cover).
2 securing screw (2)
Begin.