Cub Cadet CC-949 Service Manual page 12

Self-Propelled Mower
6.8. Remove the mounting cap. See Figure 6.8.
Mounting cap
Figure 6.8
6.9. Disconnect the barrel end of the cable by align-
ing the cable with the slot on the control lever
and sliding it out. See Figure 6.9.
Align cable with slot
and slide it out
Figure 6.9
Lower handle cover
Slot
6.10. Slide cable out of the cable ties on the handle
bar and discard.
NOTE: If the control lever needs repair take the
lower handle cover off and replace the control
lever. See Figure 6.10.
control lever
6.11. Reinstall in reverse order.
6.12. To adjust the traction control, turn the thumb
wheel in the control handle. See Figure 6.12.
Thumb wheel
6.13. Adjust the cable so that:
• The wheels drive with sufficient force when the
handle is squeezed.
• It takes reasonable effort to squeeze the lever.
• The wheels disengage completely when handle
is released.
8
Figure 6.10
Figure 6.12