Installing the Palmrest
1.
Align and press the palmrest on the computer until it snaps into place on all the sides.
2.
Connect the touchpad and power-button cables to the system board.
3.
Tighten the screws to secure the palmrest to the system board.
4.
Flip the computer and tighten the screws to secure the palmrest to the computer.
5.
Install:
a) keyboard
b) optical-drive assembly
c) memory module
d) access panel
e) battery
6.
Follow the procedures in
Removing the Input/Output (I/O) Board
1.
Follow the procedures in
2.
Remove:
a) battery
b) access panel
c) keyboard
d) palmrest
3.
Disconnect the I/O cable from the system board.
4.
Remove the screw that secures the I/O board to the computer and lift the I/O board from the computer.
20
After Working Inside Your Computer .
Before Working Inside Your Computer .