Whirlpool WFW92HEFW-WW Use & Care Manual page 21

REMOVING THE DISPENSER (cont.)
Dispenser Drawer
Removing the Dispenser
To remove:
1. Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to
remove the dispenser.
3. Lift off cover panel by
pulling straight up.
To replace:
1. Slide cover panel back
onto posts on dispenser.
2. Align edges of dispenser
with guides in washer,
then slide dispenser
back into slot.
CLEANING LOAD & GO
(on some models)
It is recommended that you rinse out the Load & Go
cartridge when changing detergent types or concentrations,
or when the washer will not be used for an extended period.
1. Pull dispenser out until it stops.
2. Lift out the Load & Go
™
3. Lift cover on cartridge and flush interior thoroughly with
warm water.
4. Allow to air dry or wipe with a clean, soft towel.
IMPORTANT: Cartridge is not dishwasher safe.
NON-USE AND VACATION CARE
Operate your washer only when you are home. If moving,
or not using your washer for a period of time, follow these
steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer to avoid flooding due
to water pressure surges.
HELPFUL TIP: Attach a reminder note to the washer
to turn the water back on before washer's next use.
3. Clean the dispensers. See "Cleaning the Dispensers."
CARTRIDGE
™
™
cartridge.
21