Whirlpool HSCR80420 Use & Care And Installation Manual page 20

WATER
CONDUCTIVITY
SETTING
The programme starts automatically
at the end of the delay period . On
programme start, the delay on the
display is replaced by the remaining
programme duration .
When selecting a delay, the original
programme duration appears again
after the maximum possible delay of
23 hours . To exit the settings mode
again without setting a delay, select
The drying results are affected by the
conductivity of the water used
during washing . If, by modifying the
available dryness levels (iron
dry; cupboard dry; extra dry), you are
not satisfied with the final
drying results, you can adapt the
water conductivity level .
The dryer comes with preset level 2 .
Choose between
level 1 (most damp results)
and level 5 (most dry results) .
Press and hold the Programme
button until the Conductivity
Adjustment symbol on the
display blinks .
the default programme duration .
To cancel a delay which has already
been started:
Either press Start/Pause to cancel
the delay . To start the selected
programme immediately, press Start/
Pause again .
Or press and hold On/Off to cancel the
complete programme setting .
Turn the knob to adjust the level (1 –2
– 3 – 4 - 5) . Press the knob to confirm
the selected level .
This operation is not needed for every
drying cycle . Once the most
satisfying water conductivity level has
been identified, you no
longer need to modify it .
EN
21