Surface Units - Hotpoint RB74jG Use And Care Manual

Surface Units

Clean the area under the drip
pans often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, plug-in units are
removable and stay-up unit lifts
up and locks in the up position.
Caution: Be sure all controls are
turned to OFF and surface units
are cool before attempting to lift
After I ifting the stay-up unit or
trim rings and drip pans under the
units and clean them according to
directions in the Cleaning Guide on
Plug-In Surface Units
Plug-in units can hc rcmovcd.
plug-in unit tibout 1" ahovc
it–-and you can pul I it out.
Do not lift a plug-in unit more
than 1:' If you do, it may not lie
flat on the trim ring when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1" above the trim
ring can permanently damage
the receptacle.
To replace a plug-in unit:
. First place the drip pan, then
the trim ring into the surface unit
cavity found on top of the cooktop
so the unit receptacle can be seen
through the opening in the pan.
Insert the terminals of the plug-in
unit through the opening in the drip
pan and into the receptacle.
Guide the surface unit into place
so it fits evenly into the trim ring.
Note: The drip pan must be under
the trim ring.
CAUTION
Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
unit plug terminals.
Do not attempt to clean, adjust
or in any way repair the plug-in
receptacle.
The 3-in-1 Stay-Up
Surface Unit
Stay-up unit cannot be removed.
can lift the stay-up unit upward
You
about 6" and it will lock in the up
position.
To reposition the stay-up unit:
Replace the drip pan and trim
ring into the recess in the cooktop.
. Put the trim ring in place over
the drip pan. The drip pan must
under the trim ring.
Guide the surface unit into place
so evenly into the trim ring.
it fits
I
be