Yamaha TDM TWIN 900 Owner's Manual page 23

Right
1
2
1. Engine stop switch " / "
2. Start switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12350
Start switch "
Push this switch to crank the engine
EAU12400
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
EAU12460
"
Hazard switch "
". When re-
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard light (simultaneous flashing of all
turn signal lights).
The hazard light is used in case of an
emergency or to warn other drivers
EAU12500 when your vehicle is stopped where it
"
might be a traffic hazard.
CAUTION:
EAU12660
Do not use the hazard lights for an
/ "
extended length of time with the en-
" before starting
gine not running, otherwise the bat-
" to
tery may discharge.
EAU12710
"
ECA10050
EAU12732
"
" posi-
3-9
ECA10061
2
3
4
5
6
7
8
9