Yamaha YFM350RW Owner's Manual page 89

5. Remove the oil filter element cover by remov-
ing the bolts, and then remove the oil filter el-
ement.
1. Oil filter element cover
2. Bolt
3. Oil filter element
4. O-ring
6. Clean the oil strainer and oil filter element with
solvent.
7. Check the O-rings for damage and replace it if
necessary.
8. Install the oil filter element and O-ring.
NOTE:
Make sure that the O-ring is properly seated.
9. Install the oil filter element cover by installing
the bolts, and then tighten them to the speci-
fied torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
10. Install the oil strainer, compression spring, O-
ring and engine oil drain bolt. Tighten the en-
gine oil drain bolt to the specified torque.
ECB00320
CAUTION:
Before installing the engine oil drain bolt, be
sure to install the O-ring, compression spring
and oil strainer.
Tightening torque:
Engine oil drain bolt:
32 Nm (3.2 m·kgf, 23 ft·lbf)
11. Add the specified amount of the recommend-
ed engine oil, and then install and tighten the
engine oil filler cap.
8-12
8