Adjusting Trim Angle (Power Tilt Models) - Yamaha F13.5A Owner's Manual

2. Remove the trim rod from the clamp
bracket while slightly tilting the outboard
motor up.
3. Reposition the rod in the desired hole.
To raise the bow ("trim-out"), move the rod
away from the transom.
To lower the bow ("trim-in"), move the rod to-
ward the transom.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
EWM00400
WARNING
Stop the engine before adjusting the
G
trim angle.
Use care to avoid being pinched when
G
removing or installing the rod.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
NOTE:
The outboard motor trim angle can be
changed approximately 4 degrees by shifting
the trim rod one hole.
EMU27901
Adjusting trim angle (power tilt
models)
EWM00750
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ZMU02007
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
Use the power tilt switch located on the
G
bottom engine cowling (if equipped)
only when the boat is at a complete
stop with the engine off.
Tilt the engine to the desired angle using the
power tilt switch.
Operation
UP
DN
ZMU02811
34