Replacing A Headlight Bulb - Yamaha YZF-R1 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Specified fuses:
Main fuse:
50.0 A
Backup fuse:
10.0 A
Ignition fuse:
15.0 A
Headlight fuse:
25.0 A
Signaling system fuse:
10.0 A
Turn signal light fuse:
10.0 A
Radiator fan fuse:
15.0 Ax 2
Electronic fuel injection fuse:
15.0 A
6
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
6. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
7. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
8. Place the cowling in its original po-
sition, and then install and tighten
the quick fastener screws.
1. Slot
2. Projection
NOTE:
ECA10640
Make sure that the projections are in-
serted into the slots.
9. Install the quick fasteners.
NOTE:
To install a quick fastener, push its pin
back so that it protrudes from the fas-
tener head, then insert the fastener and
push the protruding pin in until it is flush
with the fastener head.
6-32

Replacing a headlight bulb

1. High beam headlight bulb
2. Low beam headlight bulb
This model is equipped with quartz bulb
headlights. If a headlight bulb burns
out, replace it as follows.
To replace a high beam headlight
bulb
1. Disconnect the headlight coupler,
and then remove the bulb cover.
EAU33900