Replacing The Fuses; Replacing The Headlight Bulb - Yamaha XENTER HW151 Owner's Manual

Replacing the fuses

1
1. Fuse box
The fuse box is located beside the bat-
tery compartment under panel A. (See
page 6-8.)
If a fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15132]
Periodic maintenance and adjustment
EAUT3752
Specified fuses:
Main fuse:
20.0 A
Ignition fuse:
7.5 A
Signaling system fuse:
15.0 A
Headlight fuse:
15.0 A
Backup fuse:
7.5 A
TIP
After removing and installing the main
fuse, be sure to turn the main switch
from "ON" to "OFF" three times in
three-second intervals to initialize the
idle speed control system.
3. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.

Replacing the headlight bulb

This model is equipped with a halogen
bulb headlight. If a headlight bulb burns
out, replace it as follows.
NOTICE
Take care not to damage the follow-
ing parts:


6-28
Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it free
from oil, otherwise the transpar-
ency of the glass, the luminosity
of the bulb, and the bulb life will
be adversely affected. Thor-
oughly clean off any dirt and fin-
gerprints on the headlight bulb
using a cloth moistened with al-
cohol or thinner.
Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of a
wattage higher than specified.
1. Remove cowling A together with
the headlight unit. (See page 6-8.)
EAUT3661
1
2
ECA10651
3
4
5
6
7
8
9
10
11
12