Yamaha VERSITY VP300 Owner's Manual page 61

1
2
3
ZAUM0439
1. Engine oil filler cap
2. Maximum level mark
3. Minimum level mark
3. Wait a few minutes until the oil
settles, remove the oil filler cap,
wipe the dipstick clean, insert it
back into the oil filler hole (without
screwing it in), and then remove
it again to check the oil level.
NOTE :
The engine oil should be between the
minimum and maximum level marks.
PERIODIC MAINTENANCE AND MINOR REPAIR
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
1
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
ZAUM0583
1. Engine oil drain bolt
To change the engine oil
6-14
1. Start the engine, warm it up for
several minutes, and then turn it off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap
and the engine oil drain bolt to
drain the oil from the crankcase.
1
1
6