Variable Trolling Rpm Switches; Trim Tab With Anode - Yamaha F100D Owner's Manual

EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could dis-
tract the operator, increasing the risk of
collision with another boat or an obstacle.
UP
DN
1. Power trim and tilt switch
NOTE:
For instructions on using the power trim and
tilt switch, see page 46.
EMU30900

Variable trolling RPM switches

The trolling speed can be adjusted when the
outboard motor is trolling. Press the "
switch to increase the trolling speed and
press the " " switch to decrease the trolling
speed.
NOTE:
The trolling speed changes approximately
G
50 r/min each time a switch is pressed.
If the trolling speed has been adjusted, the
G
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds approx-
imately 3000 r/min.
1
ZMU04231
Basic components
For instructions on using the variable troll-
G
ing RPM switches, see page 43.
1. Variable trolling RPM switch
EMU26243

Trim tab with anode

The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run af-
ter the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
If the boat tends to veer to the left (port side),
"
turn the trim tab rear end to the port side "A" in
the figure. If the boat tends to veer to the right
(starboard side), turn the trim tab end to the
starboard side "B" in the figure.
ECM00840
CAUTION:
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it will
become ineffective as an anode.
19