Toshiba 2000 User Manual page 26

Chapter 2 Configuration
Used to set the combination during transmission word count setup (MODE 1 switch).
2
Transmit/receive OFF
Transmit
Receive
Controller
MD4 to 7 are all set to "OFF" at shipment.
•
Notch side
The above figure is set to node address "00". (Actual setting should be between 1 and 99.)
Align the notch side of the knob with the desired value.
10
Table 2-5 Mode 2 setup switch (2)
Mode MD6
OFF
ON OFF
OFF ON
ON ON
Address setup switch (decimal rotary switch)
Use to set the slave's node address (1 to 99). Set to "1" at shipment.
NA x 10: 10's digit (module lower side)
NA x 1: 1's digit (module upper side)
MD7 Combination
Transmit + Receive (IN/OUT)
Transmit only (INPUT)
Receive only (OUTPUT)
Set freely from controller
Notch side
Notch side
Figure 2-7 Node address setting
model 2000 PROFIBUS Module User's Manual for S2T/S2E
NAx1
NAx10