Leveling Freezer Drawer - Electrolux ei28bs55is1 Use And Care Manual

Leveling Freezer Drawer

(if necessary)
1 Check gasket seal around top, bottom,
and sides of freezer drawer.
2 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two
on each side) to allow drawer to rotate.
Remove hex
head drawer
screw
Do Not Remove
Other Screws
Remove
Hex
Head Drawer
Screw
3 Close drawer and recheck the seal
on the gasket (A). Open the drawer
grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
Push
Against
Freezer
Drawer
A
4 Tighten four drawer screws.
5 Recheck gasket seal.
Level Refrigerator & Adjust
Doors (if necessary)
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must rest
firmly on the floor.
• The sides should tilt ¼ inch (6 mm) from
front to back (to ensure that doors close
and seal properly).
• Doors should align with each other and
be level.
Most of these conditions can be met by
raising or lowering the adjustable front rollers.
Remove hex
head drawer
screw
Remove
Hex
Head Drawer
Screw
Grab
Drawer
at Center
from Both
Sides
Then
Pull
Drawer
Out
B
Installation
To level the cabinet using the front rollers:
1 Slightly open freezer drawer. Lift the
toe grille and gently pull forward (see
illustration).
2 You can raise or lower each door. Use
a ⅜ inch socket wrench to turn the
adjustment screws (1 per side).
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
3 Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg
until it contacts the floor.
Door
Anti-tip
Leg
5 Install the toe grille by fitting into place.
Door
Raise
Lower
7