Display - Miele G 6860 Operating Instructions Manual

Guide to the appliance

Display

General
The display is used to select or set the
following:
– the programme
– the FlexiTimer (Delay start)
– the Settings menu
The display can show the following:
– the stage the programme is at
– the estimated time left for the pro-
gramme to run
– the energy and water consumption
(EcoFeedback)
– any relevant fault messages and in-
formation
To save energy, the dishwasher
switches off after a few minutes if you
do not press any buttons during this
time.
To switch the dishwasher back on
again, press the  button.
8
Settings menu
The Settings menu is used to alter the
dishwasher's electronics to suit differ-
ent requirements. You access the Set-
tings menu by pressing a specific but-
ton combination (see "Settings menu").
The arrows in the display indicate fur-
ther options. You can use the  arrow
buttons next to the display, as appropri-
ate, to select these further options.
The OK button is used to confirm a
message or setting and also to move to
the next menu or another level.
The option which is selected will have a
tick  next to it.
To exit a sub-menu, use the  arrow
buttons to select the
the display and confirm your choice
with OK.
If you do not press any of the buttons
for several seconds, the display with re-
turn to the previous level. You may need
to enter your settings again.
Back  option in