Setup; Installing The Handle - Toro 22176TE Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Handle
Bolt (5/16 x 1-1/4 inches)
Washer
Thin locknut (5/16 inch)
1
Bolt (5/16 x 1-1/2 inches)
Locknut (5/16 inch)
Bag support rod
Cap locknut
Cable tie
2
No parts required
Self-tapping screw
3
Fuel tank
4
Discharge tunnel plug
5
No parts required
Note: Determine the left and right sides of the
machine from the normal operating position.
Step
1

Installing the Handle

Parts needed for this step:
1 Handle
2
Bolt (5/16 x 1-1/4 inches)
4 Washer
2 Thin locknut (5/16 inch)
2 Bolt (5/16 x 1-1/2 inches)
2
Locknut (5/16 inch)
1 Bag support rod
2 Cap locknut
1 Cable tie
Procedure
1. Mount the handle to the outside of the lawn
mower housing (using the bottom hole) with 2
Description
1. Handle latch
2. Bag support rod
2. Secure the handle latches to the handle with
8
Qty.
1
2
4
2
2 Install the handle.
2
1
2
1
–
Install the starter rope.
2
Install the fuel tank and fuel line.
1
1 Install the discharge tunnel plug.
–
Fill the crankcase with oil.
bolts (5/16 x 1-1/4 inches), washers, and thin
locknuts (5/16 inch) (Figure 3).
Figure 3
3. Cap locknut (2)
4. Handle
2 bolts (5/16 x 1-1/2 inches), washers, and
locknuts (5/16 inch) (Figure 3).
Use