Toshiba TECRA A6 Owner's Manual page 121

User Password Is / Supervisor Password Is
These two fields show that User /Supervisor Passwords are set or not.
Set
Clear
Set User Password / Set Supervisor Password
Enter this field always shows the message.
While this field is highlighted, press [Enter]. The following message is shown:
If there is an old password then setup will prompt with the following window instead and a
current password will be required to be entered at first:
User can type password in field of Enter New Password, and re-enter password in field of
Confirm New Password for verification.
If verification OK:
The supervisor password is set complete after user press [Enter].
If verification fails:
If password on boot is required, the password must be set otherwise it cannot be enabled.
The formats of the password are as follows:
Length: No more than 8 characters.
Characters: Alphanumeric keys only. The shift status, Ctrl, Shift, Alt, and Capital, are
ignored.
System Password is set.
System Password is not set.
Set Supervisor Password:
Enter New Password
Confirm New Password
Set Supervisor Password:
Enter Current Password
Enter New Password
Confirm New Password
Setup Notice
Changes have been saved.
[Continue]
Setup Warning
Passwords do not match.
Re-enter password.
[Continue]
6 The BIOS Setup Program
[ ]
[ ]
[ ]
[ ]
[ ]
6-9