Behringer MINIFEX FEX800 Quick Start Manual page 5

8
MINIFEX FEX800
MINIFEX FEX800 Controls
Controls
(EN)
(1)
(2) (3)
Front panel control elements of the FEX800
The two LED displays show the effect preset currently selected.
(1)
One LED is assigned to each preset.
Use the PRESETS control to select one of the 16 effect presets.
(2)
The EDIT control allows you to edit one effect parameter.
(3)
The center position corresponds to the default setting
programmed for the preset.
The TAP/SELECT button performs two functions:
(4)
• TAP (tempo entry): Hit the button several times in
the tempo of the music piece to adapt the delay time of
presets 9 and 15 or the modulation speed of presets 10-12.
The button starts flashing in the corresponding tempo.
• SELECT (additional effect parameter):
Press this button to choose between two different
effect characteristics when using presets 1-8,
13-14, 16. When the button lights up this means that
the corresponding parameter of the selected preset
has been activated.
Use the INPUT LEVEL control to adjust the input signal level.
(5)
Please be sure to set a level that is sufficiently high but does not
overload the unit.
(8)
(4) (5) (6) (7) (9) (10)
The L + R LED display is for monitoring the input level.
(6)
It comprises 6 LEDs. When the CLIP LED lights up, this indicates
that digital distortion may occur at the input of the FEX800.
In this case, the input signal level must be reduced.
Use the MIX BALANCE control to adjust the ratio of original
(7)
vs. effect signal. Turn the control fully to the right to hear only
the processed effect signal. Turn it fully to the left to hear only
the unprocessed input signal.
The IN/OUT button enables/disables the effect signal.
(8)
The button lights up when the input signal is being processed
by the FEX800. In order to hear the processed signal you have
to set a suitable ratio of effect vs. direct signal using the
MIX BALANCE control .
(7)
Use the OUTPUT LEVEL control to adjust the output level.
(9)
The � switch turns your MINIFEX FEX800 on and off. The switch
(10)
lights up when the unit is switched on.
9
Quick Start Guide
(11) (12) (13)
Rear panel connectors of the FEX800
The FEX800 is connected to the mains using a 2-pole
(11)
POWER connector jack. A matching mains adaptor is
included with the unit.
A single footswitch can be connected to the IN/OUT connector.
(12)
This footswitch allows you to remotely control the IN/OUT
button on the front panel and switch the effect signal
(8)
on and off.
The two OUTPUT connectors are on 1/4" connectors and provide
(13)
a balanced left/right signal.
(14)
The two INPUT connectors are on 1/4" connectors and can be
(14)
used for unbalanced signals. A single mono signal should be
connected to the L jack.
Check Out behringer.com for Full Manual