Table of Contents
Advertisement
Closed caption
[Only for NTSC, 480i input]
1 )
Press ▲▼ to select [Closed caption].
2 )
Press ► or the <SELECT> button to
enter the submenu.
Closed caption
J
1 )
Press ▲▼ to select [Closed caption]
and then press the <SELECT> button.
2 )
Press ▲▼ to select [Off], [CC1], [CC2],
[CC3] or [CC4].
Color
J
1 )
Press ▲▼ to select [Color] and then
press the <SELECT> button.
2 )
Press▲▼ to select [Color] or [White].
Note
The closed caption is mainly used in the north America.
z
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
You can select [Closed caption] when [NTSC] or [480i]
z
signals are input.
Part of characters may not displayed when high
z
compensation valued are set in [Keystone].
Closed captions are not displayed while the menu screen
z
appears.
Lamp power
This function allows you to change brightness of the
screen.
1 )
Press ▲▼ to select [Lamp power] and
then press the <SELECT> button .
2 )
Press ▲▼ to select one among the
modes as below.
You can also press the <LAMP> button to
z
display [Lamp power].
Brightness according to the input
Auto
signal.
The lamp power output is
Normal
maximum.
The lamp power output is 70%
Eco1
of the Normal mode.
The lamp power output is 53%
Eco2
of the Normal mode.
Remote control
This switching function prevents remote control
interference when operating several projectors or
video equipment at the same time.
1 )
Press ▲▼ to select [Remote control].
2 )
Press ► or the <SELECT> button.
3 )
Press ▲▼ to select one among the
seven codes.
This projector provides 7 different remote
z
control codes: [ALL], [Code 1]~[Code 6].
Note
When operating the projector under [ALL] code, you can
z
operate several projectors at the same time. If you want
to operate the projector independently, you must switch
to other code.
When different codes are set on the projector and on the
z
remote control, any operation cannot be made. In that
case, switch the code on the remote control to fit the
code on the projector.
If the batteries are removed from the remote control for a
z
long period of time, the remote control code will be reset.
Security
This function allows you to use the Key lock and PIN
code lock function to set the security for the projector
operation.
1 )
Press ▲▼ to select [Security].
2 )
Press ► or the <SELECT> button to
access the submenu.
Key lock
J
This function locks the control panel and remote
control buttons to prevent operation by unauthorized
persons.
1 )
Press ▲▼ to select the desired items
as below.
Unlocked.
Lock the operation of the control
panel. To unlock, use the remote
control.
Lock the operation of the remote
control. To unlock, use the control
panel.
Setting
53
ENGLISH -
Advertisement
Table of Contents
