Panasonic KX-WT125 Operating Instructions Manual page 69

Troubleshooting and Error Messages
Problem Possible Cause
The handset
stops working
during operation.
You cannot use The handset will not
the handset function during a power
during a power failure because the PBX
failure. stops emitting radiowaves.
The headset A headset tone cannot be
does not work. heard when receiving an
incoming call when the
headset is attached.
Noise is
frequently heard.
Two short beeps The radio signal is weak.
are heard during
a conversation.
You charged The battery charge
the batteries contacts may be dirty.
for 7 hours, but
the beep tones
It is time to change the
sound, and
batteries.
Àashes (needs to
be charged) after
a few telephone
calls.
While charging These are normal
the batteries, the conditions.
handset and the
AC adaptor feel
warm.
Solution
Re-insert the batteries and
try again.
(See "Battery Installation" on
page 5.)
• Make sure the headset
ringer setting is set to
"On". (See "Incoming
Option" on page 59.)
• Make sure the headset
jack is connected
properly. (See "Location of
Controls" on page 8.)
• Place the handset and CS
away from other electrical
appliances.
• Move closer to the CS.
Move closer to the CS.
Clean the battery charge
contacts without damaging
them and charge once more.
Replace with new batteries.
69