Cycle982 Tool: Measure Turning And Milling Tools; Function Overview - Siemens SINUMERIK 840D sl Programming Manual

6.3

CYCLE982 tool: Measure turning and milling tools

6.3.1

Function overview

Function
Cycle CYCLE982 permits
● calibration of a tool probe,
● measurement of tool lengths L1 and L2 for turning tools with cutting edge positions 1 to 8,
● the tool lengths for milling tools and drills on turning machines,
● the radius for milling tools.
NC software of at least SW 5 is needed for measuring milling cutters/drills.
Programming
CYCLE982
Note
Tolerance parameters _TSA, _TDIF and _TZL must be entered taking into account machine
data
• MD 20360 TOOL_PARAMETER_DEF_MASK bit0 and bit1
in conjunction with the offset target
• geometry and wear.
The following measurement and calibration tasks are supported by CYCLE982:
● Calibrate as preparation for measurement/automatic measurement
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
The 4 switching positions of the probe are
roughly known and entered in the array of
the associated tool probe. Positioning of
the calibration tool with respect to the
probe is performed in the cycle. It is only
possible to determine the switching
position that is in the measuring axis _MA
and measuring direction according to
starting position.
Measuring Cycles for Turning Machines
6.3 CYCLE982 tool: Measure turning and milling tools
277