Belt Clip Installation And Removal; Mic/Sp Cap Installation - Vertex Standard EVX-261 Operating Manual

Belt Clip Installation and Removal

 To install the Belt Clip: align the
Belt Clip to the groove of the Bat-
tery pack, then press the Belt Clip
downward until it locks in place
with a "Click."
8
B Y B
EFORE OU
 To remove the Belt Clip: use a
fl at head screw driver to press the
Belt Clip Tab away from the bat-
tery pack to unlock the Belt Clip,
then slide the Belt Clip upward to
remove it.
Belt Clip Tab
EGIN

MIC/SP CAP Installation

Install the MIC/SP cap with the sup-
plied screws.
 Use only the supplied screws
when install the MIC/SP cap.
 This radio does not keep the
Water Resistant Rating (IP55)
when the MIC/SP cap is not in-
stalled in the MIC/SP jack.
EVX-261 O M
PERATING ANUAL