Control Panel - Electrolux EUC19001W User Manual

4 electrolux
• Adequate air circulation should be
around the appliance, lacking this leads
to overheating. To achieve sufficient ven-
tilation follow the instructions relevant to
installation.
• Wherever possible the back of the prod-
uct should be against a wall to avoid
touching or catching warm parts (com-
pressor, condenser) to prevent possible
burn.
• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
SERVICE
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.

CONTROL PANEL

1 2
Green On/Off Indicator Light
1
Temperature Regulator and On/Off
2
Switch
Yellow Fast Freeze Indicator Light
3
Acoustic Signal Stop and Fast Freeze
4
Switch
Red Alarm Indicator Light
5
SWITCHING ON
1. Allow the appliance to stand for 4 hrs
after installation.
2. Insert the plug into the wall socket.
3. Turn the Temperature Regulator clock-
wise to a temperature lower than << -
16 °C >> position.
4. The Green On/Off Indicator Light will
light up and Red Alarm Indicator Light
will blink.
Downloaded from Fridge-Manual.com Manuals
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
ENVIRONMENT PROTECTION
This appliance does not contain gasses
which could damage the ozone layer,
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
3 4
5. The lighting up of the Green On/Off In-
dicator Light means that the appliance
is switched on.
6. The blinking of the Red Alarm Indicator
Light means an improper temperature
in the freezing compartment. In addi-
tion, an intermittent sound can be
heard, which can be stopped by press-
ing the Acoustic Signal Stop and Fast
Freeze Switch once.
7. When switching on the freezer for the
first time, the Red Alarm Indicator Light
will blink until the internal temperature
has reached a level required for the
safe conservation of frozen food.
SWITCHING OFF
1. To turn off the appliance, turn the Tem-
perature Regulator to the "O" position.
are recyclable.
5