Electrolux EUC19001W User Manual page 11

1. Fit the spacers into the holes. Make
sure that the arrow (A) is positioned as
shown in the picture.
2. Turn counter-clockwise the spacers
through 45° until they lock into place.
LEVELLING
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front (2). If
necessary adjust the feet by removing the
spacer (1).
LOCATION
The appliance should be installed well away
from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air
can circulate freely around the back of the
cabinet. To ensure best performance, if the
appliance is positioned below an overhang-
ing wall unit, the minimum distance be-
Downloaded from Fridge-Manual.com Manuals
tween the top of the cabinet and the wall
unit must be at least 100 mm . Ideally, how-
ever, the appliance should not be posi-
tioned below overhanging wall units. Accu-
rate levelling is ensured by one or more ad-
justable feet at the base of the cabinet.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet
must be at least 10 mm to allow the door to
open enough so that the shelves can be re-
moved.
Warning! It must be possible to
disconnect the appliance from the
mains power supply; the plug must
therefore be easily accessible after
installation.
DOOR REVERSIBILITY
Important! To carry out the following
operations, we suggest that this be made
with another person that will keep a firm
1
hold on the doors of the appliance during
the operations.
2
To change the opening direction of the
door, do these steps:
1. Remove the plug from the power sock-
et.
2. Tilt back the appliance carefully so that
the compressor cannot touch the floor.
electrolux 11