Changing Midi Settings - Optimus MD-1150 Owner's Manual

42-4039.fm Page 27 Friday, March 3, 2000 8:55 AM
Here is the data that can be received
with this keyboard and the correspond-
ing control number.
Effect
Modulation
Volume
Pan
Hold1 (Sustain)
The MD-1150 can send Hold1 Control
Change data only when you connect a
sustain pedal and press it.
CHANGING MIDI
SETTINGS
The MD-1150 lets you change two MIDI
parameters, Tone Map and Keyboard
Channel.
Keyboard Channel — sets the channel
for sending MIDI data to an external de-
vice (Default: 01). The MD-1150 re-
ceives MIDI data on channels 1 through
4 and 10 only. The data received on oth-
er channels are ignored. For transmis-
sion of MIDI data, you can use any of 16
channels.
1. Repeatedly press
until
TUNE/MIDI Keybd Ch
2. Within 5 seconds, press
select the channel you want.
Tone Map — sets the range of program
change values received/recognized by
this keyboard.
1. Repeatedly
Control
Number
2. Within 5 seconds, press
1
7
10
64
TRANSPOSE/
appears.
or to
– +
press
until
TUNE/MIDI
appears.
select the setting you want.
N: Normal Tone Map. This setting
allows receipt of 0 to 99 program
changes. Each program change
corresponds to one of the key-
board's prerecorded tones.
G: General MIDI Tone Map. This
setting allows receipt of all 0 to 127
program changes. Any data over
100 are translated to the closest
tone the MD-1150 has. See "Note
Table" on Page 33 for details.
Select G when you listen to General
MIDI data from an external device.
TRANSPOSE/
TonMap=N
or to
– +
27