Assembling And Unfolding The Handle - Toro Super Recycler 20794 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1. Assembling and Unfolding
the Handle
Procedure

Assembling and unfolding the handle

improperly can damage the cables, causing an
unsafe operating condition.
• Do not damage the cables when assembling
and unfolding the handle.
• Ensure that the cables are routed to the
outside of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
2. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 3), but do not
tighten the handle bolts.
1. Washer
2. Handle bolt
Important: Route the cables to the
the handle (Figure 3).
3. Rotate the handle rearward (Figure 4).
Figure 3
3. Handle end
outside
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height in the Operation
section.
5. Torque the handle bolts to 120 to 160 in-lb (14 to
17 N⋅m).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height.
of
6
Figure 4