Bissell 1305 series User Manual page 10

Maintenance & Care
Cleaning the inner cyclone
1. Follow instructions 1-3 on page 9 under
Cleaning the pre-motor filter.
2. Remove the inner cyclone by pulling up and
separating it from the container.
3. The inner cyclone may be wiped clean with
a damp cloth. Make sure all parts are dry before
replacing.
4. The screen can be removed, by separating
it from the cyclones. Pull down to remove and
rinse with warm water. Let the screen completely
dry before replacing.
5. Reassemble container and place back on
vacuum.
Replacing the post-motor filter
1. Follow instructions 1-2 on page 9 under
Empty dirt container.
2. Press red filter release button, which is
visible when the dirt container is removed
from vacuum base.
3. Remove the filter cover.
4. Remove the post motor filter by grasping
each side of filter and pulling out.
3. If the post motor filter appears dirty, replace
with new post motor filter.
NOTE: For optimal performance it is
recommended that you clean and replace
filters every 3-6 months.
www.BISSELL.com
10
WARNING
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
2. 3.
2. 3.